After cleaning your surface area wet the area again using a spray bottle and a solution of about 5 soap 95 water.
Wet apply vinyl decals.
The wet method involves making a soap solution using a mixture of dish soap and water to get both the application surface and the adhesive side of the decal wet before applying the decal.
Those who are still learning need the flexibility that wetting solutions can offer.
The wet application method applies a vinyl graphic to a substrate by using a fluid to assist with positioning.
Please take your time.
Face the decal with the tissue paper cover toward you.
You can apply most smaller decals without using water but for large and very large stickers this trick is a life saver.
How to apply vinyl decals using dry method 1.
All dirt and wax must be removed to give the vinyl proper surface to adhere to wiping area with rubbing alcohol will give you really good stick 2.
Remove protective backing from vinyl.
The dry method as its name indicates does not use fluid but rather depends on the skill of the installer to correctly position the film.
Big tape at top leave the decal attached to the wax paper.
Remember you cannot get the graphics too wet.
Use the wet method.
Slower than the dry method but no air bubbles.
The only difference is the application of soapy water to the vinyl before application.
Installing your own.
Learn how rapid remover works so effectively at removing residue adhesive and even see how rapid tac ii application fluid makes easy work out of applying calendered film on glass outdoors while it s snowing.
Industry experts walk you through wet vinyl applications from routine to the most extreme of installation conditions.
By wetting down the vinyl first you are able to reposition your graphics during application.
Apply the sticker while the area is still wet.
Tape the decal at the top edge using the biggest masking tape you can find.
Just a little bit of dish soap in water is all you need to help install without bubbles.
Begin to apply vinyl to the vehicle.